Complex 1″ Logo on R-Buster steel hand stamp. Custom designed logo stamp. a) Shank sized to fit b) 5″ long for easy gripping c) Double pass engraved for extra clarity d) Custom heat treat for long life e) Soft Hammer Read more
5/16″ Custom Logo Stamp CMH31LOGOS- R-Buster logo Logo to Read: PING in 5/32” (Comc Sans Ms Font) Flat Faced 5/32” CHARACTERS For Pricing please see: http://www.columbiamt.com/store/Logo_R-Buster_Hand_Stamps.html For quote request please email store@columbiamt.com the following information: 1)Line drawing of design 2)Size Read more
1/2″ Custom Logo Medium 1/2″ Logo on R-Buster steel hand stamp. Custom designed logo stamp. a) Shank sized to fit b) 5″ long for easy gripping c) Double pass engraved for extra clarity d) Custom heat treat for long life Read more
1″ Custom Logo CMH100- Logo R-Buster plus series hand stamp featuring: *5″ long shank for easy grip *Double pass super cut characters for extra clarity and depth *HC custom heat treat for durability *Safety end (soft hammer end) for reduced Read more
82095001- Custom Hot Stamping Die Featuring:
A. 2″ Diameter X 1″ Long
B. ENGINE OIL (with arrows)
C. Flat Face Characters for Marking Plastics
D. Heat Treated Tool Steel
E. ACC Clean Coat to Prevent Rust
F. (1) 5/16-18 tapped hole and (2) .312″ diameter dowel pin holes
** Ref blank Z3052
Hot Stamp Die LCMSHAE5568 6-line, concave stamp to read: SLING LEG SAFE WORKING LOAD 4000 POUNDS 10001-2644390 MFR 3X694 SPM8EE-10-C-F004 S/N 2008 Note: reference job Y8592 for character size and font info.
Custom Roll Die & Shank R800-100 Roll Attachment with 1″ diameter shank mounting. AF2324-Custom roll die for use with R800 tooling 1/8″sharp faced Gothic font characters to read: UWT INC. MADE IN USA PAT. PENDING
PR651-AB9339 special retro-fit SLIDE-A-MARK air powered block marking system including: A. Floor to line fabricated marker weldment with floor mounting holes and machined marker mounting surfaces B. 651-OB-60-P2-NL SLIDE-A-MARK unit with stamp to engine block telescoping pre-loading feature C. 6″ Read more
Q: Why = does CMT recommend a short pulse on the valve for air impact = markers? A: An air impact marker is designed to provide an = “instantaneous” force. After the force is dissipated in the = initial Read more
Q: To summarize: The system worked in the = past.CMT recently did service on the marker and = controller.When marker was returned, it worked when hooked up to a = laptop at your desk.When connected to a PLC and other Read more