Sometimes a 2D code is required on the OD of a round part. This can be a challenge with the rounded surface. While the mark can be made – the camera reading will be nearly impossible due to the reflection of the light of the curved surface. CMT has overcome this challenge implementing 2 upgrades to the standard 2D code
Marking Solution tested: IM-MS60 Part Description: Brass Cast Part Material: Cast Mark info: Character size: 5/16” Mark info: # of characters: 2D Square dot Depth of mark Esitmated.003 PSI Used 30 Mark cycle time required: 12 seconds Reason for test mark: Clarity of Mark Read more…
Dot Peen 1 Marking Solution tested: IM-M125 Part Description: Aluminum Tag Part Material: Aluminum Mark info: Character size: 3/16” Mark info: # of characters: 10 characters Depth of mark Estimated .003 PSI Used 25 Mark cycle time required: 3.5 seconds Reason for test Read more…
CMT Test Marking Lab Results Marking Solution tested: Dot Peen and Diamond scribe Place sample photo here Part Description: Ducting material Part Material: Sheet metal Mark info Character size: “1/4″”” Mark info # of characters: Read more…
RE: IM-M75 Sample marks These sample marks were done using the IM-M75. This programmable is the same machine that you currently have on your floor. We could offer you some custom fixturing to make set up fast and flawless. By using the IM-M75 you can eliminate the use of tooling Read more…
Stamps can be found on this page: http://www.columbiamt.com/store/Jewelry_R-Buster_Hand_Stamps-ss3.html
Part:Piston Aluminum Part Material: aluminum Character size: 1/8″ Number of characters: 3 Note: one of information Machine used: Laser Cycle time:3 Seconds For more on the marking system used please see:http://columbiamt.com/CMT-Dot-Peen-Scribe/EcoMark_Laser_Marking_Machine_2.html#210