Machined Aluminum Dot peen and Scribe Sample marks

Published by Drew Davis on

 

Sample marks showing Dot-Peen and Scribe on Machined Aluminum surface.

 

Sample Dot-Peen Mark

Model: IMID60 I-Mark I series

Character size: 1/8”

Depth of mark: .003” – .004” (not including raise up)

Marking Speed: 4-5 characters per second

Travel and Communication time <2sec

 

 

 

 

 

 

Sample Scribe Mark

Model: IMIS60 I-Mark I series

Character size: 1/8”

Depth of mark: .004”- .005” (not including raise up)

Marking Speed: 4-5 characters per second

Travel and Communication time <2sec

 

 

 

 

 

 

 

Notes:

  • Dot-Peen is a “rougher” mark. It is made up of a bunch of small dimples. This produces a more easier seen mark
  • Scribe is using a Ballscrew drive system. The mark is deeper, but the largest benefit is the reduction of the noise.