Question: How small of a character can I mark with the I-Mark M-75 series dot peen marker with the “fixed dot” style marking stylus? Answer: There are many factors that can affect the results of small character marking. The “fixed dot” marking stylus provides a deeper mark than our standard Read more…
Q: I’m working with a I-Mark Series impact printer and need to know how long the I need to hold the cycle start ON for to get the marker started? A: The I-Mark marking system only requires a momentary Start Signal to begin the marking sequence. As short at Read more…
Q: We have an IM-300 with two ID60 heads at a customer’s facility. This unit is the first of two that has been in service for a few months. Our customer has raised a few questions that we are looking for answers for. 1. What is the expected life of Read more…
Q: We are experiencing a periodic Loss of “Marking In Progress” signal? A: We understand that there is a periodic communication issue with one of our systems. Please understand that all CMT I-Mark systems are fully tested and of course we do stand behind our warranty policy. Sometimes a look Read more…
IM-C150-ST-AS-ZE I-Mark programmable scribe unit includes all required components for setting up a marking station: *Marking head with 4″ x 6″ (150mm x 100mm) marking window and air scribe diamond styls *Controller Series-200 With 3rd axis upgrade for Electric Z *IM Z axis Approach Slide – Electric *I-Mark PC software Read more…
Q: We are having a problem with one of the I-mark system we have for the Paccar project. During production it will just stop and the pin will be stuck up in the marker, how we recover is to go in and pull the pin out of the unit. Do Read more…
Q: After programming system and shutting down PC, and then turning it on again, there are now no mapped controllers? A: The problem with not being able to connect is that on the laptop the Wireless network interface still ON while trying to establish a connection. Windows 7 is funky… it tries Read more…
Q: I am using a Modicon M340 controller. I would like to understand how you specify the addressing for the program file selection. Do I create the address in the stamper or are they fixed? A: It is fixed. Send over a bitwise value for the binary program selection. Within Read more…
Q: What software platform does I-Mark run on? A: I-Mark 2.0 currently only runs on all versions of Windows XP, Vista, Win 7 and Win 8, both 32 and 64 bit. Please note the older versions 1.73 and before, only run on 32 bit platforms.
Q: Does the rotator alsways have to be connected to the I-Mark system? Q: Yes. If a rotator is purchased then the complete system must be connected to assure a properly “homed” cycle.