May 2012 – Page 2 – MarkingWiki Presented by Columbia Marking Tools

Bolt Size Required

Q: There has been a question of whether or not we should be mounting the unit with M10 screws or M12 screws. We are proceeding with M12 screws as I stated in the earlier email below, but the question has been brought up. Please address whether M10 screws or M12 Read more…

By Marc Steele, 13 years ago

Air Impact FAQ

Mounting Slide-A-Mark

Q. The model calls out for a 17/32 clearance hole to mount these units. I don’t see any dowels on the drawings for these units. We are mounting these with M12 Screws, are we required to heel the marking unit due to the force? What is the preferred method of Read more…

By Marc Steele, 13 yearsMay 4, 2012 ago